Initial Tuning
The one-page document that comes with the GRA-1900T antenna detailing the jumper positions on the coil and the lengths at which to set the whip for each band didn’t seem to match up all that well, which led to some frustration out in the field.
I decided to use my NanoVNA to reconstruct my own instructions for using the antenna. I extended the whip fully and recorded the resonant frequency for each jumper position of the coil. Knowing those frequencies, I can set the jumper and shorten the whip until the SWR sweep on my x6100 is happy. The SWR graph on the x6100 can be misleading sometimes, because it often shows a birdie dip or 2 in the graph, but now I’ll always know that I’m to shorten the whip to get where I need to be.
I’ll eventually apply labels to the coil with these frequencies.
US-1425 Susquehannock State Park
I took the GRA-1900T out to Susquehannock State Park for a field test. My plan to tune the antenna worked well. I set the jumper for the frequency below my intended operating frequency and shortened up the whip until the x6100 showed a good SWR curve. Easy!
Oops, Broken Fishing Pole Mast
Since I hadn’t used the fishing pole at the park, I forget I had it and left it behind when I packed up. 2 days later, I returned to retrieve it. Some kids had found it, had trouble collapsing it, dug in the dirt with it, and broke a section.
I was able to put it back together with the remaining sections, and I 3d-printed a new fork/loop to make it useful for supporting wire.