Scanning

I have my UV-K5 and UV-K6 running aubs 00.07 firmware. I added a simplex frequency (446.100MHz) to use as with my local cross-band repeater in position 110. I added the new channel to scan list 1.

Upon powering on the radio, I could scan lists 1 (local repeaters) and 4 (satellites) together. When I press the up arrow to advance off an active channel, the scan would now skip list 1, and go right to 4, and continue to skip list 1. Before I realized it was happening, I thought the day was super quiet.

I dropping the repeater frequency from scan list 1, and the scanning behaved correctly. I tried removing another channel from scan list 1, and reintroducing channel 110 to the list, but that didn’t fix it, so it’s not an issue with the count.

Much of scan list 1 is lower in the channels, so I moved my new repeater frequency from channel 110 to position 30, right after all my other simplex channels. That seems to work fine, so that’s how I’m leaving it.

I may need to try some more things and figure out a reproduction to file a bug on the project:

• Is it something about the frequency of 460.100?
• Or is channel 110 the problem?
• Would another frequency in that spot be a problem?
• Are there other channels that would trigger the issue?

I drove out to West Chester yesterday, but I’ve not bothered looking up and adding repeaters for the area. Instead, I could set the spectrum analyzer on the UV-K6 (or K5) to scan the 145MHz-148MHz, stepping on 5.00kHz, and I had a pretty good picture of any repeaters to hear out there.

Once I heard something, I could pop open RepeaterBook on my phone and see what it was, but it saved me lots of trouble programming anything into the radio ahead of time to not necessarily need it.